Week - 5 - Modelling Spotwelds

AIM:- Material Modeling from Raw Data OBJECTIVE:-  Using the given video link, extract the data from the figure, and used it for validation. Create a material model for the Dogbone specimen using the diagram of the true stress-strain curve (graphite iron). From the above condition simulate…

AIM:-calculate the Stretch Ratio by comparing the ELFORM OBJECTIVE:- Create a block of 10mmx10mmx10mm dimension with 10 elements for each direction and use the material card attached (Ogden_Material.k) that is representative of the material properties from the above figure. Use appropriate boundary conditions to simulate…

AIM:-Modelling SpotweldsOBJECTIVE:-In this assignment, you will model spot welds for the given assembly of parts and run a crash test similar to the one in assignment 4. Details about the spotweld location is in the image below. The yellow line signifies the spotweld directions. You need to use 3-7 spot welds along this…

AIM:- Crash Box Simulation OBJECTIVE:-In this assignment, the student needs to simulate a crash test for a crash box for which mesh is given. A crash box is a highly energy-absorbing structure that crashes on application of loads and reduces impact on other components nearby. A full-fledges crashbox is a highly sophisticated…