Effect of viscosity changes in gearbox transmission system

1.Introduction Gearboxes are used to increase torque while reducing the speed of a prime mover output shaft (e.g. a motor crankshaft). This means that the output shaft of a gearbox rotates at a slower rate than the input shaft, and this reduction in speed produces a mechanical advantage, increasing torque. Gearbox…

Arun Gupta
updated on 23 May 2019

Read more Projects by Arun Gupta (62)

Project 1 : Flow over Ahmed Body

Objective:

Flow over Ahmed's Body The Ahmed body represents a simplified, ground vehicle geometry of a bluff body type. Its shape is simple enough to allow for accurate flow simulation but retains some important practical features relevant to automobile bodies. This model describes how to calculate the turbulent flow field around…

24 Nov 2023 05:24 AM IST

STAR-CCM

Project 1 : CFD Meshing for Tesla Cyber Truck

Objective:

Objective : To Identify & clean up all the topological errors in the given Tesla Cyber Truck Car model. To create a surface mesh. To Create a wind tunnel around Tesla Cyber Truck Car. To create a volumetric mesh to perform an external flow CFD analysis simulation. Introduction : ANSA : ANSA is a Computer-aided engineering tool…

09 Sep 2023 11:52 AM IST

Project 1 - Meshing of Floor Panel

Objective:

AIM:- To mesh the given floor panel for the given quality criterias without any failure in the elements. Project description:- FLOOR PANEL GIVEN:- Procedures for Meshing a 2D component:- i) Importing the CAD model into ANSA:- The cad model is imported into the Ansa software by clicking File ---> New command. ii) Geometry…

04 Mar 2023 05:12 AM IST